Reading progress

JIMTOF 2026

Live from JIMTOF | NEXTAS booth W3035

Tokyo Big Sight, West Hall 3: zero-point and pneumatic demos on the table, floor photos, and one Short.

By NEXTASOctober 29, 20262 min read

Visitors gathered at the NEXTAS booth under a header that reads W3035

On this pageOn the table

We are in West Hall 3 at Tokyo Big Sight this week, booth W3035, through 31 October. The September post was a preview. This one is different: we are already on the floor, and the table is set.

Visitors mostly stand around the table and ask how a fixture leaves the seat, how it comes back to the same spot, and how that handoff runs inside an automation cell.

On the table

Zero-point and pneumatic demos are on the table, with catalogs beside them. If a photo or the Short does not show a readable model, we do not invent one.

Short from the floor, booth W3035.

Three people talking at the NEXTAS table beside a blue multi-port demo and round plates in clear cases — Visitors at the table with the blue multi-port demo and round plates.

Close view of a blue multi-port demo, round plates in clear cases, and catalogs on the NEXTAS table — The blue block, plates in cases, and catalogs on the table.

A visitor holding a catalog at the NEXTAS table under the booth header — A catalog changes hands under the booth header.

The backdrop

Crowd at the NEXTAS booth with the READY FOR AUTOMATION backdrop and the W3035 header — The booth wall and the W3035 header.

READY FOR AUTOMATION on the backdrop is booth branding. Do not read it as a spec sheet.

Come by, or send this

If you are still at the show, come to W3035 and talk. If you cannot get there, send the machine model, a table drawing or photo, whether release is by hand or by air, roughly how heavy the fixture and the part are, and whether a robot loads them. Write the item code if you have one. If you do not, write unknown. We will match that to zero-point systems or the pneumatic zero-point plate and reply.

Booth W3035

Send the machine and the drawing

Zero-point systems · Pneumatic zero-point plate

Send the inquiry

Four-station zero-point receiver plate with four circular modules

Compare receiver models, pull studs and mounting interfaces for your fixture.

View specifications

NEXTAS pneumatic zero-point plate product view

Check the pneumatic release circuit, seating checks and robot-loading interface.

View specifications

NEXTAS JIMTOF 2026 exhibition banner showing the booth design, October 26–31, 2026 and Tokyo Big Sight

Meet NEXTAS at JIMTOF 2026, West Hall 3, booth W3035, from October 26 to 31, 2026. Compare zero-point receiver and plate options for your machine. Bring its model and table drawing, and contact us before visiting to confirm the display scope.

Four round NEXTAS zero-point receivers mounted on a square plate

Once you have chosen a zero-point architecture, freeze the exact receiver, mating interface, full stack, load case, services and acceptance test. A family name, pitch or force label is not enough for a purchase order.

NEXTAS CNC workholding quote workflow using machine, part, tolerance and fixture inputs

Workholding quotes can stall when the request lacks the facts needed to size a fixture. Send the part, machine, tolerance and process details up front. The supplier can then check the job, flag missing inputs, and confirm the quote scope and timing.